ProForm 560 Crosstrainer User Manual download pdf (Page 8)

If you purchase the optional chest pulse sensor (see

page 16), follow the steps below to install the receiver

included with the chest pulse sensor.

1. Make sure that the power cord is unplugged. Remove

the indicated Screw (3) and the Access Door (76) from

the back side of the Console Base (85).

2. Connect the wire on the receiver (A) to the indicated wire

extending from the Console Base (85). Hold the re-

ceiver so the small cylinder is oriented as shown and

is facing the Console Back. Attach the receiver to the

plastic posts on the Access Door (76) with the two in-

cluded small screws.

3. Make sure that no wires are pinched. Reattach the

Access Door (76) with the Screw (3). Discard the other

wires included with the receiver.

Small

Cylinder

Wire

Small

Screws

5. Attach the Latch Housing (73) to the left Upright

(

84) with two Screws (3);

tart both Screws

and then tighten them. Note: Make sure that

the large hole in the Latch Housing is on the

indicated side.

Remove the knob from the pin. Make sure that

the collar and the spring are on the pin. (Note: If

there are two collars, place one on each side of

the spring.) Next, insert the pin into the Latch

Housing (73). Then, tighten the knob onto the

pin.

Spring

Collar

Knob

6. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear

plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-

mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is

used to adjust the walking belt (see page 19).

Large Hole

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

ProForm 560 Crosstrainer User Manual Page 8