TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance is needed, call our toU-free HELPLiNE at
1-800-736-6879, Monday through Saturday, 7 a.m, until 7 p.m. Central Time (excluding holidays).
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 7). Use only a single-outlet surge suppressor
that meets all of the specifications described on page 7. Important: The treadmill is not compatible
with GFCl-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill I c
near the power cord. If the switch protrudes as
I
shown, the circuit breaker has tripped. To reset the Tripped
circuit breaker, wait for five minutes and then press
the switch back in.
Reset
PROBLEM: The power tums off during use
SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the
circuitbreaker has tripped, wait for five minutes and then press the switch back in,
b. Make sure that the power cord is plugged in.
c. Make sure that the two wires under the console are fully plugged in (refer to assembly step 4 on
page 6). WARNING: Do not disconnect or connect the wires while the power cord is
plugged in.
d. Unplug the power cord, wait for five minutes, and then plug the power cord back in.
e. Remove the key from the console. Reinsert the key fully into the console.
f. if the treadmill still will not run, please call our toll-free HELPLINE.
PROBLEM: The displays on the console do not function properly
SOLUTION: a.
Remove the key from the console and unplug the
power cord. Remove the screws from the hood and
carefully remove the hood. Locate the Reed Switch
(21) and the Magnet (43) on the left side of the Pulley
(42). Turn the Pulley untilthe Magnet is aligned with
the Reed Switch. Make sure that the gap between
the Magnet and the Reed Switch is about 118". If
necessary, loosen the Reed Switch Screw (76) and
move the Reed Switch slightly. Retighten the Screw.
Re-attach the hood, and run the treadmill for a few
minutes to check for a correct speed reading.
PROBLEM: The pulse display on the console does not function properly
SOLUTION: a. Wash your hands before using the pulse sensor. Clean the pulse sensor with a damp cloth and
mild detergent.
12
(26 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals