ProForm PFTL61930 User Manual download pdf (Page 28)

Locate the Reed Switch (24) and the Magnet (18) on

the left side of the Pulley (114). Turn the Pulley until

the Magnet is aligned with the Reed Switch.

Make

sure that the gap between the Magnet and the

Reed Switch is about 1/8”. If necessary, loosen the

Screw (25) and move the Reed Switch slightly.

Retighten the Screw. Reattach the Hood, and run the

treadmill for a few minutes to check for a correct

speed reading.

PROBLEM: The walking belt slows when walked on

SOLUTION:

a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 10.

b. If the walking belt is overtightened, treadmill perfor-

mance may decrease and the walking belt may be

permanently damaged. Remove the key and

UN-

PLUG THE POWER CORD

. Using the included

allen wrench, turn both rear roller adjustment bolts

counterclockwise 1/4 of a turn. When the walking

belt is properly tightened, you should be able to lift

the edges of the walking belt 3 to 4 inches off the

walking platform. Be careful to keep the walking belt

centered. Plug in the power cord, insert the key, and

run the treadmill for a few minutes. Repeat until the

walking belt is properly tightened.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the key

and

UNPLUG THE POWER CORD. If the walking

belt has shifted to the left, use the allen wrench to

turn the left rear roller bolt clockwise 1/2 of a turn; if

the walking belt has shifted to the right, turn the

bolt counterclockwise 1/2 of a turn. Be careful not to

overtighten the walking belt. Plug in the power cord,

insert the key, and run the treadmill for a few minutes.

Repeat until the walking belt is centered.

b. If the walking belt slips when walked on, first remove

the key and

UNPLUG THE POWER CORD. Using

the allen wrench, turn both rear roller bolts clockwise

1/4 of a turn. When the walking belt is correctly tight-

ened, you should be able to lift each side of the walk-

ing belt 3 to 4 inches off the walking platform. Be

careful to keep the walking belt centered. Plug in the

power cord, insert the key, and walk on the treadmill

for a few minutes. Repeat until the walking belt is

properly tightened.

PROBLEM: The upper body arms come off, do not slide easily, or make a squeaking noise

SOLUTION:

a. See UPPER BODY ARM TROUBLESHOOTING on page 24.

Top

View

1/8”

114

Rear Roller Adjustment Bolts

3–4”

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

ProForm PFTL61930 User Manual Page 28

Comments to this Manuals

Related products and manuals for Treadmills ProForm PFTL61930