ProForm 325i Treadmill User Manual download pdf (Page 6)

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is

coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of

the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there

is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches and your own phillips screwdriver ,

adjustable wrench , wire cutters , and needlenose pliers .

For help identifying the assembly hardware, refer to the PART IDENTIFICATION CHART below. Note: The

assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags

until instructed to do so.

1” Tek Screw (37)–4

Wheel Bolt (64)–2

5/16” Star

Washer (48)–4

1/4” Star

Washer (76)–4

3” Bolt (61)–4

2” Bolt (114)–4

3/4” Screw (2)–15

1/2” Silver Screw

(49)–2

Crossbar Screw

(39)–2

1” Bolt (63)–4

Wheel Nut (13)–2

1/4” Washer

(38)–4

1. Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the tread-

mill onto its left side as shown. Partially fold the Frame

(86) so that the treadmill is more stable. Do not fully

fold the treadmill until it is completely assembled.

Open part bag A.

Attach four Base Pads (57) to the bot-

tom of the Base (69) with four 1” Tek Screws (37) (three

are shown).

Attach a Wheel (66) to the inner side of the Base (69) with

a Wheel Bolt (64) and a Nut (13) as shown.

Do not over-

tighten the Nut. The Wheel should be able to spin freely.

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

No comments

ProForm 325i Treadmill User Manual Page 6