ProForm 380 F Elliptical User Manual download pdf (Page 10)

10. Apply a generous amount of the included

grease to the Pivot Axle (16). Then, apply a

small amount of grease to two Wave Washers

(88).

Insert the Pivot Axle (16) into the Upright (2).

Place a Wave Washer (88) on each end of the

Pivot Axle.

Slide the right Upper Body Leg (6) onto the

Pivot Axle (16). Attach the right Upper Body Leg

with an M6 x 16mm Patch Screw (80) and a

Large Axle Cover (20). Attach the left Upper

Body Leg (6) in the same way.

Grease

12. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

elliptical exerciser.

11. Apply a small amount of grease to a Pedal Arm

Axle (21). While another person holds the right

Pedal Arm (14) inside the bracket on the right

Upper Body Leg (6), insert the Pedal Arm Axle

through the Upper Body Leg and the Pedal

Arm.

Then, tighten an M6 x 16mm Patch Screw (80)

and an Axle Cover (22) into each end of the

Pedal Arm Axle (21).

Repeat this step for the other side of the

elliptical exerciser.

Grease

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

ProForm 380 F Elliptical User Manual Page 10